Dip Switch Ethernet Interface Tm-T88V How To Configurethe PC
Dip Switch Ethernet Interface Tm-T88V Series Printer The

To change the IP address, select TCPIP under Configuration.You can enter a new IP address and gateway address.

Required Components Epson POS Printer with Connect-It Ethernet adapter Local Area Network (LAN) running TCPIP Windows computer with LAN connection Epson Printers Covered TM-T88III TM-T88IV TM-T88V TM-U220 TM-U230 TM-U590 TM-U675 TM-H6000III Step by Step Installation The installation step vary slighting depending on the type of Ethernet card you have.

Over the past few years Epson has offered 3 types of Ethernet cards, Type II, II and IV.

Each has a different set of features and a different way of setting them up.

The module can be set byaccessing it directly using a web browser or by a configuration utility.

This type of module can also act as a device typePrint server to be used by more than 1 computer.

Dip Switch Ethernet Interface Tm-T88V Series Printer The

Installing and Setting the Connect-It Ethernet Adapter (Type IV)Install the Connect-It Ethernet adapter into the Epson TM series printer The Type IV adapter can replace the existing adapter and is held in place by 2 screws.

If changing a printer to Ethernet you must change the specific dip switch on the Epson printer to allow for the Ethernetcard.

How to connect an Epson POS printer with Ethernet Interface 342011 12:27:20 PM (Key: DIP SW2-8 On: refers to slide switch number 8, on switch bank 2, is turned On) CablingUse a regular LAN patch cord to connect the printer to the LAN.

RJ-45 Female (connector on computer and adapter end) Ethernet cards use CAT56 patch cords Getting initial printer and Ethernet adapter settings (Type IV)Get the initial settings of the Ethernet adapter.

Run the printer self test (hold down the feed button while turning on theprinter).

The printer will print a list of initial settings including interface type and buffer capacity.

How to connect an Epson POS printer with Ethernet Interface 342011 12:27:20 PM A strip will print showing the MAC address, Gateway (GW), IP address and IP assignment method (manualauto).

Changing the IP Address of the AdapterNow comes the tricky part.

To be able to change the IP address on the adapter you need to be able to connect with it.

Todo this you most likely need to change the IP address of your computer to a value that makes the adapter accessible.You can then connect to the adapter, make the change to the adapter, then return the computer back to its originalsettings.

Resetting the AdapterYou can reset the UB-E02 Ethernet Interface card to factory defaults by holding down the push button on the card (seearrow above) while turning on the printer power and continuing to hold it down for 5 seconds.

This causes all internalsettings to return to their factory defaults.

Setting the IP Address on your ComputerIn Windows you can access the wired Ethernet adapter in the Network Connections applet in the Windows ControlPanels (Internet ProtocolTCPIP properties, allow you to enter an IP address.) Make a note of the existing settings, youllbe returning to those settings when your done.

Set the IP address to an address in the same domain as the adapter.

Forexample of the adapter shows an IP address of 172.16.10.63 you could change the computer to 172.16.10.2.

Do not setthe computer to the same address as the Ethernet adapter on the printer.

You might have to reset the computers adapterfor the new settings to take place.

Logging onto the Adapter using TMNet WebConfig (Type II or Type IV)TMNet web configuration allows you to access the adapter via your network using a web browser.

Dip Switch Ethernet Interface Tm-T88V How To Configurethe PC

Generally speaking theadapter must be in the same sub domain as the computer to be able to log on (see previous section for how to configurethe PC to the same subdomain) Using a web browser such as Internet Explorer you should nowbe able to connect to the adapter by entering the IP address ofthe adapter directly into the address bar of the browser.